Product information "Rubber Boot (Rubber Sleeve) – For Buggy GS Moon 260"
Rubber Boot (Rubber Sleeve) – For Buggy GS Moon 260
Protection for Critical Joints – Keeps Dirt and Moisture Out, Protecting Your Axle or Steering Joints!
Rubber boots are essential protective components on vehicles. They hermetically seal moving joints, such as steering joints or drive axle joints (CV joints), preventing the ingress of dirt, water, and dust. At the same time, they keep the necessary lubricating grease inside the joint.
A porous, cracked, or damaged rubber boot causes the grease to escape and dirt to enter. This quickly leads to increased wear and premature failure of the underlying joint (e.g., tie rod end or CV joint).
This high-quality Rubber Boot is the precise replacement, suitable for the:
Buggy GS Moon 260
Product Details and Benefits
Robust Protection: Shields critical joints from contamination and wear.
Flexible Material: High-quality rubber that withstands temperature fluctuations and movements.
Durable Seal: Ensures that the lubricating grease remains in the joint.
Precise Fit: Direct replacement for the original GS Moon 260 part.
Specification
Detail
Article Type
Rubber Boot (Steering/Axle Protection)
Quantity
1 Piece
Quality
High-Quality Replacement Part
Suitable for
Buggy GS Moon 260
Article No.
065-730103
Important Note on Verification and Compatibility
Rubber boots are specifically sized for the respective joint in terms of size and mounting diameter (small and large opening). Please visually compare the item with your old boot. Also, pay attention to all article information, especially the dimensions of the boot, to avoid fitting inaccuracies. Before installation, it is essential to check if the joint itself is still intact and to apply new grease.
Installation Instructions (Intended as Guidance Only!)
Important Note: Replacing the boot often requires the corresponding joint to be partially or completely disassembled.
Preparation: Secure the vehicle and dismantle the component whose boot is to be replaced (e.g., tie rod or drive shaft).
Disassembly: Remove the old clamps and the damaged boot. Thoroughly clean the joint of dirt and old grease.
Replacement: Fill the joint with fresh, suitable lubricating grease. Slide on the new boot and secure it firmly at both ends with the appropriate clamps.
Completion: Reassemble the component in reverse order and check for correct function.
Ensure the longevity of your joints on the Buggy GS Moon 260! Order the Rubber Boot (Art. No. 065-730103)
Related links to "Rubber Boot (Rubber Sleeve) – For Buggy GS Moon 260"
