Steering knuckle right PGO BR250-DS Bugrider

Steering Stability Reinstated! – Right Steering Knuckle / Spindle for PGO BR250-DS Bugrider

Heavy-duty front wheel carrier – Fits 150cc & 250cc Buggies

Ensure precise handling! This right steering knuckle (spindle) is a crucial component of the front suspension. Specifically designed for the PGO BR250-DS Bugrider, it is also compatible with many 150cc models such as the PGO 150 or Hammerhead 150 due to identical construction. It acts as the primary mount for the wheel hub and steering linkages.

Note on condition: The part is new and functional, but may show visible storage marks (scratches in the paint).

Technical Specifications & Details

• Component: Steering Knuckle / Spindle (front right)

• Total Length: 495 mm

• Thread Sizes: 2 x small threads M12 / 1 x large thread M14

• Compatibility: PGO BR250-DS, PGO 150, Hammerhead 150cc, and similar buggies.

• Material: High-strength cast steel.

Installation & Maintenance Instructions: (For guidance purposes only)

• Visual Compatibility: Before installation, perform a visual check. Compare the total length (495 mm) and thread sizes (M12/M14) exactly with your original part.

• Surface Prep: Clean the spindle shaft thoroughly. Apply a thin layer of grease to aid bearing installation and prevent rust.

• Safety: Always use new locking nuts or cotter pins for the ball joints and tie rod ends. Vibrations in off-road use can loosen old fasteners.

• Alignment: A wheel alignment check is mandatory after replacing the steering knuckle to ensure proper handling and prevent uneven tire wear