Rear sprocket 32 teeth PGO BR150-DS Bugrider

Rear Sprocket 32 Teeth – For PGO BR150-DS Bugrider

The Final Drive Sprocket for Your PGO Bugrider

This Rear Sprocket is a precisely fitting spare part with 32 Teeth and was specifically designed for the PGO BR150-DS Bugrider. It is a critical component of the final drive, significantly determining the gear ratio and thus the acceleration and top speed of your Buggy.

Sprockets are subject to high wear. Worn teeth, often in a hook-shaped "shark fin" form, lead to increased chain wear, erratic operation, and a reduction in drive efficiency. When replacing the chain or the front sprocket, the rear sprocket must always be renewed to ensure the full lifespan of the new chain set. The note "Install immediately and drive off" highlights the straightforward fitment of this spare part.

Top Features and Benefits:

• Precise Calibration: 32 teeth for the optimal gear ratio of the PGO BR150-DS Bugrider.

• Direct Fitment: Specifically designed for mounting on the rear wheel carrier of the PGO Bugrider.

• Restores Efficiency: Re-establishes the clean and efficient operation of the chain drive.

• High-Quality Material: Made from robust steel to withstand the stresses of off-road use.

Detailed Dimensions:

Product Specifications:

Important Installation Note:

• Chain Set: For maximum lifespan, you should always replace the rear sprocket, chain, and front sprocket as a set.

• Securing: Pay attention to the correct tightening torque and the secure fastening to the wheel carrier.

• Chain Tension: After installation, check and adjust the chain tension.

Ensure the transfer of full engine power to the rear wheels!